Why is there no pressure at my hot water faucets? If you have good water flow (“pressure”) at hot water faucets, but it’s cold, then the water supply pipi...

When should I be worried about water hammer? The Water Hammer Problem The effect of the shockwaves can damage the pipes and knock them loose, and also dam...

Can you connect PVC to cast iron? Though not as easy as using Fernco special rubber donut, you can use lead to connect PVC into a cast iron hub too. If do...

How do I reset my Rheem hot water heater? Where is the reset button on a Rheem water heater? Turn the water heater’s gas valve switch to the “OFF” positio...

Do tankless water heaters take longer? The initial cost of a tankless water heater is greater than that of a conventional storage water heater, but tankle...

How do I reset my Procombi boiler? To reset boiler, turn the mode control knob (A) to reset position and immediately turn knob back to required setting. T...

How long does it take for a water heater to heat up after resetting? The average gas tank water heater will take roughly 30 to 40 minutes to heat up after...

Why is my toilet making a horn noise? If your toilet is making a foghorn noise, it could be because of a loose washer inside the “float”—a black, ballock-...

What do you need to know about a flow switch? A flow switch, sometimes referred to as a flow sensor or flow indicator, is a device used to monitor the flo...

How high off the ground is a clawfoot tub? The bathtub will be somewhere between 14 inches and 17 inches in height. Are clawfoot tubs practical? Though th...